Versie 2.8.1 van de Community Edition van pfSense is uitgekomen. Dit pakket is gebaseerd op het besturingssysteem FreeBSD en richt zich op router- en firewalltaken. Het is verkrijgbaar in de gratis Community Edition en een betaalde Plus-uitvoering, die voorheen als Factory Edition werd aangeboden. Het is in 2004 begonnen als een afsplitsing van m0n0wall vanwege verschillende visies bij de ontwikkelaars en in de loop van de jaren uitgegroeid tot een router- en firewallpakket dat in zowel kleine als zeer grote omgevingen kan worden ingezet. Voor meer informatie verwijzen we naar deze pagina. In deze uitgave zijn de volgende veranderingen en verbeteringen aangebracht:
Auto Configuration BackupDynamic DNS
- Fixed: AutoConfigBackup entries show incorrect timestamps #16209
Interfaces
- Fixed: Dynamic DNS fails to update AAAA record for Route53 and No-IP services #16249
- Changed: Update list of Dynamic DNS services that are only reachable over IPv4 for AAAA record updates #16251
OpenVPN
- Fixed: Using IPv4 VIPs on PPPoE interfaces with
if_pppoe
causes looping #16235- Fixed: PPPoE IPv6 gateways are unavailable without Router Advertisements when using
if_pppoe
#16265Operating System
- Fixed: Kernel panic in OpenVPN
if_ovpn
due to use-after-free of mbuf #16319Rules / NAT
- Fixed: Kernel Panic in
if_qlnxe
kernel module when loaded viakldload
#16101- Changed: Reduce writes to disk when using ZFS #16210
- Added: Allow custom ZFS pool names #16212
- Fixed: Panic in PF if the declared packet length is longer than the actual packet #16318
- Fixed: Multiple removable filesystem panics #16320
- Added: Support 2.5G SGMII (SFP GPON ONT) in
bxe
driver (QLogic NetXtreme II BCM57810) #16321System Logs
- Fixed: Firewall rules with an interface address for the NAT64 source always use the interface itself #16250
- Fixed: Firewall rules are not performing source tracking when Sticky Connections option is enabled #16282
UPnP IGD & PCP
- Fixed:
syslogd
does not respect the configured IP address binding #16285
- Fixed: UPnP IGD & PCP status page does not show “disabled” message after the service has been enabled then disabled #16274