"Down under" heeft Overclockers Australia een review gemaakt van de nieuwe Titan Majesty twins socket cooler waar ze eerder een preview van hadden. Je zou hem (of haar? zie poll) het beste kunnen omschrijven als 2 aan elkaar geplakte orbs die dan op hun kant op de processor zitten. Het geheel moet dan gekoeld worden door de 2 interne fans die op 3200tpm hun rondjes draaien. Met de looks zit het wel goed, maar hoe zit het met de rest? De onderkant die tegen de processor zit, lijkt niet echt mooi afgewerkt. Het is duidelijk te zien dat er kleine groeven in het vlak zitten, dus opschuren is eigenlijk geen luxe. Verder bleek de koeler lastig te monteren op de Asus A7V waarop hij getest werd, maar ook zijn er geluiden dat hij lastig op een Abit KT7 past. Over deze problemen een korte quote:
With the Majesty Twins, this was exacerbated by two things. Firstly, the width of the cooler across the base meant it was fouled by a large capacitor near the socket and the separate power regulator board on the A7V. [...] Secondly, the clip itself is designed so that the holes on one side are partly blocked by the base of the sink itself. CoolPC obviously experienced this with the Abit KT7 also - they provide an extra sheet of instructions with their own technique for moving the clip up and mention the KT7 specitically.[break]In de test wordt de koeler tegenover de Thermaltake Super Orb gezet, waarbij gebruik werd gemaakt van een AMD Thunderbird 950Mhz@1,75V. De resultaten waren echter teleurstellend: daar waar de Super Orb de processor op zo'n 54 graden wist te houden, werd hij met de Titan 69 graden. Bij deze laatste temperatuur werd gebruikt gemaakt van de standaard heatpad die al op de koeler zat. Bij gebruik van een standaard koelpasta lag de temperatuur nog een graadje hoger: 70 graden dus. De conclusie en samenvatting is dus niet zo positief:[/break]Well, the results tell the story. Interestingly, the thermal pad seems slightly more efficient than the thermal paste. The Titan heatsink gets blisteringly hot to the touch, so thermal transfer from the CPU seems to be occurring fine, but unfortunately the unit is just not capable of getting the heat into the surrounding air. The box rates the fans at 3200rpm and they were doing between 3200 and 3400 according to the A7V's monitoring.
Admittedly, the test system was fairly poor in the case-cooling department but when compared to the Super Orb it really seems that the Titan unit was simply overwhelmed by the heat load from the Thunderbird 950. Perhaps this cooler is intended for slower CPU's, but the box says simply "SocketA and Socket370 CPU's". Keeping in mind that this chip is running at stock speed and stock voltage, and adding in the intensely frustrating (and potentially chip-threatening) time I had mounting it, I find it very hard to recommend the Titan Majesty Twins cooler to anyone who cares about anything other than sheer looks or novelty value.