3dfxCool hddHO harddisk cooler review

3DWars heeft een review geplaatst van de 3dfxCool hddHO, een harddisk cooler (want dat schijnt tegenwoordig nodig te zijn):

This cooler performed very nicely. No drivers to configure, so the software side is eliminated. The fans ran very quietly as did the hard drive. Using an 8.4 GB Seagate 7200 RPM hard drive makes noise, but it wasn't very noticeable. I played a movie in a loop for 24 hours straight, while doing other work on the computer. After 24 hours, I stopped everything, took of the case and took a look at the setup. I put my hand on the heatsink, and surprisingly there was not much heat on it. It seemed a bit odd to use a heatsink on a hard drive, but regardless of its intentions, the setup worked great. There was some more heat in the case(roughly 3 degrees higher than normal), and that was from the fans blowing the heat off of the hard drive. After seeing the pleasing results, I asked Bart Lane, owner of 3DfxCOOL, about the heatsink and here is what he had to say:

Door Femme Taken

UX Designer

14-08-1999 • 02:16

2

Bron: 3DWars

Lees meer

Reacties (2)

Sorteer op:

Weergave:

Ik heb zelf een compleet scsi systeem. Als ik mijn harde schijven niet koel, ik gebruik een koeler van TITAN (ƒ79,-) worden ze zo heet dat ik mijn handen er niet op kan leggen. En wat gebeurt er met de 10.000 toeren SCSI schijven zonder koeling? Ik weet niet of het voor IDE ook zin heeft.
mijn scsi schijfje werd ook aardig heet..
kan hem ook niet vastpakken na een paar minuten compen.

Op dit item kan niet meer gereageerd worden.